Features
- Stainless steel construction
- 4" wide pick-up head
- 9" handle
- Overspray control holes
Pricing
U1515 - 300 PSI brass valve ($104.00)
Features
- Spray is contained, which retains heat better
- Recessed divider helps in cleaning
- Stainless steel construction
- 4" wide pick-up head
- 9" handle
- Overspray control holes
- K2 or K1 jet available
Pricing
U1515C - 300 PSI brass valve ($116.00)
Features
- 4" wide clear plastic head
- 9" stainless handle
- Replaceable head is easily replaced in the field
- Brass Vee Jet
- 6" whip on low pressure
Pricing
U1530B - 500 PSI brass valve ($72.00)
Features
- Spray is contained which retains heat better
- Thumb slide vac release allows control of the amount of wetness applied
and the amount of suction
- 4" wide pick-up head
- 9" handle
- 1' whip on high pressure
- 6" whip on low pressure
Pricing
U1530SB - 500 PSI brass valve ($110.00)
Features
- Jet Side by-pass controls the pressure that comes out of the jet, by-passing
the rest into the vacuum chamber
- Needle valve allows adjustment
- Closed spray model only
- High pressure brass 800 PSI valve
- All stainless steel construction
- Thumb slide vacuum release
- Black vinyl grip on handle for protection from high heat
- Ball valve on end of 1' whip for even more control
- 4" wide head
- 9" handle
Pricing
U1515CBJ - 800 PSI brass valve ($294.00)
Features
- Pressure side by-pass allows you to control a flow of solution even when the
valve is shut off. This allows your truck mount to operate properly and allows the
operator to adjust the flow from the tool.
- Needle valve by-pass for infinite adjustment
- Closed spray model also available
- High pressure brass 800 PSI valve
- All stainless steel construction
- Thumb slide vacuum release
- Black vinyl grip on handle for protection from high heat
- Ball valve on end of 1' whip for even more control
- 4" wide head
- 9" handle
Pricing
U1515CBP - 800 PSI brass valve ($294.00)
Features
- Molded glides on the tool lips virtually eliminate any chance of fabric snagging. You can move the tool across the fabric with complete confidence.
- Easy access nose cone lets you clean and remove clogs from the unit by removing just four simple screws. No special tools required.
- Replaceable nose cone can be swapped out if chipped, cracked, or broken. Instead of having to replace the entire unit, you can attach a new nose cone and extend the useful life of your tool.
Pricing
163-220 - DriMaster DM3 w/o Handle ($519.00)
DriMaster DM3 w/ Handle ($575.00)
061-144 - Handle Only ($59.00)
